Name: How to Install the GruppeM Ram Air System for Honda Civic Type R (FK8)
Uploaded: 2020-04-24T20:20:11.041279+00:00
Duration: 899 s
Channel: GTChannel
Description: This is an in-depth install video of the GruppeM Ram Air System for Civic Type R FK8.

GTChannel

Check out the official Evasive Motorsports website

GruppeM Ram Air System for Honda Civic Type R FK8 17+

HKS SSQV 3 Blow Off Valve (Full Set)

GTChannel Signature Hoodie

Follow Evasive Motorsports (@evasivemotorsports) on Instagram

This is an in-depth install video of the GruppeM Ram Air System for Civic Type R FK8.

<p>This is an in-depth install video of the GruppeM Ram Air System for Civic Type R FK8.</p>

https://d3ev5earl6dvd0.cloudfront.net/public-media/videos/000/375/000375/video.mp4

Start with the negative cable with a 10mm socket. .

Disconnect the battery

Push the 2 air box clips and lift up. Unplug the sensor and set aside.

Disconnect MAF sensor

Pinch firmly and lift up to remove. Locate the hook the lift it out. Remove the 2 10mm bolts. Push out the rubber pins to unclip the intake box.

Remove rubber air duct

Using an extended 10mm socket, loosen the 2 bolts. Use a 5.5mm socket for the smaller set of bolts. Lift up with the rubber grommet to remove intake.

Remove air box & intake pipe

Remove philips screws and set aside. Remove the MAF sensor.

Remove MAF sensor

With a 10mm socket and a tool to remove clips, remove all necessary parts in the way. Remove rubber grommets from the intake box and set aside.

Remove some tabs, screws

Locate the new rubber grommets in the package. Place plugged grommets on each corner. Apply holed grommets and sponge tape according to instructions.

Preparing air box for install

Locate the 2 rubber studs and place according to instructions. Next, install the 90-degree bracket with a 10mm nut, followed by the second bracket secured with the 20mm spacer and the 40mm bolt. Place the second bracket under the fuse box as instructed.

Install supplied hardware

From the grommet installed previously, locate the empty hole next to it to connect to previously installed rubber stud. Make sure holes line up accordingly and fasten all bolts securely.

Install air box

Locate fixing plate, aluminum studs, and two 30mm M630s. Mind the orientation of the bracket and screw in your studs and bolts. Install funnel and sensor adapters with the supplied spacers and bolts. Attach filter securely. Install the MAF sensor in place. Next, connect the air chamber.

Assemble intake

Aim the aluminum studs into the grommets with holes and slide in intake. Tighten up hose clamps.

Install intake

Locate bolt and clip placements. Screw bolts into the unit and tighten.  .

Install front air duct

Take the plug and wrap in some electrical tape. rout the wiring behind the air box. Plug it into your MAF sensor. .

Plug in MAF sensor

Locate the GruppeM cover and lay it into place. Line up all nuts and brackets. Use the remaining 20mm bolts and line them up. Tighten up all screws and brackets once cover is lined up in place.

Related Videos